• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced technician for help.
CAUTION: To comply with the limits of the Class B digital device, pursuant to Part
15 of the FCC Rules, this device is comply with Class B limits. All peripherals must
be shielded and grounded. Operation with non-certied peripherals or non-
shielded cables may result in interference to radio or reception.
MODIFICATION: Any changes or modications of this device could void the warranty.
FAQ
How does it work?
The mophie juice pack has a rechargeable lithium polymer
battery inside. When you slide your phone into the case, a
connector at the base plugs into the port at the bottom of
phone. Flip the standby switch on the back from red to green
to start charging your phone. After using up all the power in
the juice pack, just recharge it with the included micro USB
cable for more on-the-go power. It’s as easy as that.
Why aren’t the LEDs blinking while the juice pack is charging?
After connecting to a power source, the LED status indicator
will start blinking to indicate charging. The lights will turn o
after 30 seconds allowing for a good night’s rest. Remember
to check the status indicator before you disconnect. When all
four LEDs are lit, your juice pack is fully charged.
What is the best method for charging my iPhone using the
juice pack?
Assuming the iPhone and juice pack are both fully charged,
we recommend waiting until your iPhone has 20% battery
left. When you’re in the red, ip the standby switch to green
and let the juice pack to do the heavy lifting. The iPhone
requires more power to charge past 80%, so if you want to
get the greatest battery boost from the juice pack, we
suggest ipping back to standby mode until your phone
battery is low again. This isn’t the end-all-be-all, but we like it.
What is the best method for charging my juice pack?
Connect the juice pack to a power source using the micro
USB cable that came with your juice pack. The USB cable
can be plugged in to your computer or any “Made for
iPhone” power source with a USB out. You do not need to
remove your iPhone from the juice pack to charge. Leaving
the juice pack on your phone while charging will actually
charge both the case and your iPhone simultaneously!
To Next Page
Loading...