9
Descaling Your Machine
Press and hold the Espresso and Lungo
buttons
(8, 9) for 3 seconds to enter the
de-scale mode.
The unit will beep when activated.
The buttons will repeatedly illuminate in
sequence, until the de-scale mode is
de-activated.
Fill the Water Tank
(3)
with descaling solution
(mixed to manufacturer’s recommended
guidelines) and place a container under the
nozzle.
Press the Lungo Button
(9)
and the machine
will empty the contents of the Water Tank.
The water will dispense at between 40-50°C.
The unit will beep when a cycle is activated.
Refill the Water Tank (3) with the used
descaling solution and press the Lungo
Button
(9) to repeat.
Empty and rinse the Water Tank
(3), then fill
with clean water.
Press the Lungo Button (9) to run the clean
water through the machine.
Repeat this step once more.
Press and hold the Espresso and Lungo
Buttons (8, 9) for 3 seconds to exit the
de-scale mode.
The unit will beep when the descale mode is
deactivated and the button illumination
sequence will stop.
F
ollow steps 3-5 in “Before First Use”. Approximately 45 seconds after switching the machine on, the
B
uttons
(
7,8,9)
w
ill stop flashing and remain illuminated, and the machine will emit a beep.
To Next Page
Loading...
Need help?
General
