Morphy Richards ELIPTA 47155 - Using the Steam Wand; Frothing Milk

4
6
When done, Turn the Steam Control (2) to Off
BEFORE removing the Steam Wand (3) from
the Milk.
5
Place the Steam Wand
(3)
10mm deep into a
jug of milk. Turn the Steam Control
(2)
to On.
3
Plug the coffee maker into the mains.
2
Ensure the On/Off Switch (10),and Steam
Control (2) are set to Off. Select Steam (8).
11
Fill the Water Tank (5) and place into the coffee
maker.
4
Slide the On/Off Switch (10) to On. The
Temperature Indicator Light (9) will stop
flashing when the coffee maker is ready.
WHEN FROTHING MILK ENSURE THE STEAM
CONTROL IS OFF BEFORE REMOVING THE
WAND FROM THE MILK.
WARNING
Using the Steam Wand
to froth milk
47155 rev3_Layout 1 02/09/2011 13:52 Page 4