Operating your trimmer
1 Push the on/off switch upward to
operate and down to turn off the
trimmer. Before using the trimmer
charge the unit overnight.
Make sure the charging indicator light is
on showing correct charging.
To Recharge
1 Use only the adaptor (charger) provided.
2 Charge takes 8 hours.
3 Connect plug to trimmer and plug
adaptor into the electrical socket.
4 When charging, the recharging indicator
will light up showing correct recharging.
Attachment comb
(trimming guide)
Your male grooming system provides 1
adjustable attachment comb.
Provides 5 settings of cutting length
2mm, 5mm, 8mm, 11mm and 14mm.
Trim against the direction of the hair
growth. Start at a longer setting (11mm or
14mm) to prevent accidentally trimming hair
too short.
As you become familiar with the setting,
adjust the guide to the desired trimming
length.
To trim beards
1 Comb hair outward so they are at a
maximum height and in
the same direction.
2 With the trimming
guide in place, set the
guide to the desired
setting.
3 Slide the On/off switch
to the ‘on’ position and
begin trimming.
(figure 1)
To trim outer edge of beard
and add definition
1 Hold the trimmer
diagonally with the front
of trimmer facing away
from you.
2 Start at the chin and
move back towards the
ear. (figure 2) Follow
the jawbone to cut away longer hairs on
the outer edge of the beard.
To define the beard line
1 Hold the trimmer vertically with the
front of the trimmer facing you.
2 Start with the trimmed edge of the
beard and with a downward motion,
trim the area directly under the
beard line.
6
To Next Page
Loading...