4
Morrison Bros. Co. - Dubuque, IA - 800-553-4840
918---0188 PP rev8.12.13
!
Failure to follow any or all of the warnings and instructions in this document could result in a hazardous
liquid spill, which could result in property damage, environmental contamination, fi re, explosion, serious
injury or death.
Optional Overfi ll and Reorder Label Installation
NOTE: The template (see Figure 7) is intentionally reversed (mirror image) so the labels may be placed on the
inside surface of the clear front cover. Therefore, the lettering of the labels is on the adhesive side and will read
correctly once placed.
Steps
1. Template units are shown in feet (or cm). It will be necessary to determine the desired overfi ll and reorder
points and convert those into feet (or cm) in order to use this template.
2. Remove the front face retaining ring and remove the clear front cover.
3. Place the clear cover onto the template aligning the outside edge to the outside circle.
4. Remove indicator label backing and place label on the clear cover as shown on template. Align wider end
against inside circle and narrower end pointing toward the level you want to indicate.
5. If both overfi ll and reorder labels are used, make sure each is pointing to the correct foot (or cm) reading that
provides the volumes you desire.
6. Reinstall the clear front cover with the labels on the inside. Make sure indicators are in correct location and
wording is readable before putting gauge in service. Replace the front face retaining ring making certain the
ring snaps all the way down into the groove. You will need to use pliers to squeeze the ring into the groove. The
retaining ring is correctly squeezed into place if the ends of the retaining ring do not overlap.
1
2
3
4
5
6
7
8
9
10
11
50
100
150
200
250
300
CM
FEET
Fig. 7: Over ll and Reorder Label Template
To Previous Page
Loading...