Morso Model F - Page 26

MASKINFABRIK
HARALDSVEJ21
DK-8900 RANDERS
TLF.+ 45864351 55
FAX. + 45 86 43 51 00
instructions manual
MORS0 Mitring machine
Model F
LOCATING FAULTS
G-1
/"
Faults
Incorrect cuttings
Moulding with rebate tips
The moulding is not firm
on the table during cutting
Incorrect length measures
The basic position of the
knife block is changed
The moulding is not cut
auite through
Cause
Dull knives
Knives incorrectly installed
Rebate supports incorrectly
adjusted
Fences loose
The length measure
incorrectly set
Stop beam loose
The height stop is
displaced
The forward movement
is not correct adjusted
Repair
Replace knives
See page F-2
Check the installation
See page F-2
Correct the adjustment
See page E-5
Fasten fences
See page E-3
Correct the length meas
See page E-4
Fasten stoo beam
correct the adjustment
see page E-7
correct the adjustment
see page F-4
•
Beware of the extreme
sharp knives
MORS0 F -9503 G-1/gb1
•
:
27