Ambulo 2400
AMBULATORY BLOOD PRESSURE MONITORING SYSTEM
Thank you for purchasing the Ambulo
™
2400 ABPM system. This guide will show
you how to configure and conduct a successful 24-hour ABPM procedure on a patient
using the Ambulo 2400 device, its accessories and software. Please consult the
Ambulo 2400 User Manaul for more detailed instructions, as well as other important
information and helpful tips.
Start Here
Open and inspect the contents of your system, including all accessories and
documentation. Install the Hypertension Diagnostics Suite software on a Microsoft
®
Windows
®
-based PC using the CD included with the ABPM sytem.
Install the Batteries
•
Always use fully charged NiMH rechargeable AA batteries.
•
Make sure that the batteries are installed according to the correct polarity.
•
Once powered, the LCD will turn on and the device will beep. Close the battery
compartment by replacing the cover.
Configure the Ambulo 2400 for Each Patient
•
The Ambulo 2400 must be programmed for each patient using the PC software.
This process requires only a few minutes.
•
Connect the Ambulo 2400 to your PC using the included USB cable.
•
Open the Hypertension Diagnostics Suite software.
•
Select an existing patient from the Browse Patients item or create a new one from
the New Patient item - including all relevant information.
•
Click on the Configure Device button.
•
Select the One Click Programming button
if a Default Monitoring Plan has been
defined. Alternatively, select Configure
Device Parameters. As shown on the left,
this will allow for entry of all measurement
parameters, including monitoring periods
and frequencies.
•
Once ready, send this data to the device by
clicking on the Send Data to ABPM Device
button. Configuration is now complete.
To Next Page
Need help?
General
