• Spec
o Input：5V/9V/12V, 15V 2A
o Output：5V/5W，9V/10W,12V/15W
o operating frequency：120~130kHz
• How to charge your phone wirelessly with Otto Q
o Plug the supplied USB-C to USB-C cable into Otto Q, then connect to
any USB Type-C wall charger (not included).
o For optimal performance, use a high-output wall charger (over 10 W, 1
8 W recommended) for better charging efficiency.
o A QuickChargeTM 9V charger is required to enable the fast-charging p
rotocols of Apple (7.5 W) and Samsung (9 W).
• LED behavior:
o Off: Not charging
o Breathing light: Charging
o Steady on: Fully charged
o Flashing: Foreign Object Detection error
• Foreign Object Detection Troubleshooting:
o Remove any metal objects like coins or keys between your device and
Otto Q.
o Unplug the power adapter for Otto Q then plug it in again.
o If the problem still exists, please contact support@moshi.com.
FCC Statement
Please take attention that changes or modification not expressly approved by
the party responsible for compliance could void the user’s authority to operate the e
quipment.
This device complies with Part 18 of the FCC Rules.
To Next Page
Loading...
