EasyManua.ls Logo

Motomaster Classic Series - Preparing to Charge; Assembly

Motomaster Classic Series
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
headline bars
tabs
continuation tabs
notes
warnings
headline bars
tabs
continuation tabs
notes
warnings
headline bars
tabs
continuation tabs
notes
warnings
headline bars
tabs
continuation tabs
notes
warnings
model no. 011-1977-4 | contact us 1-888-942-6686
6
headline bars
tabs
continuation tabs
notes
warnings
SAFETY
PREPARING TO CHARGE
CHARGER LOCATION
DO NOT expose charger to rain or snow.
Locate the charger as far away from the
battery being charged as the cables will
permit.
Be sure to position the power cord to prevent
it from being stepped on, tripped over or
damaged.
NEVER place charger directly above battery
being charged. Gases from the battery will
corrode and damage the charger.
NEVER set a battery on top of a charger.
NEVER allow battery acid to drop on charger.
ALWAYS charge a battery in a well-ventilated
area.
BATTERY PREPARATION
When removing battery from vehicle to
charge it, always remove grounded terminal
from battery first.
Make sure all accessories in the vehicle are
OFF in order to prevent sparks.
Be sure that the area around the battery is
well ventilated while being charged.
Clean the battery terminals. Be careful to
keep corrosion or battery acid from getting in
or around your eyes.
For batteries with removable vent caps, if
required, add distilled water to each cell until
the battery fluid reaches the level specified
by the battery manufacturer.
DO NOT overfill.
For batteries without removable vent caps,
carefully follow the manufacturer’s charging
instructions.
Study all of the battery manufacturer’s
specific precautions and recommendations
for charging and for recommended rates of
charge.
Make sure that you have a 12 V lead-acid
battery. Determine voltage of battery by
referring to the vehicles owner’s manual. If
the charger has an adjustable charge rate,
charge battery at the lowest rate first.
ASSEMBLY
Remove all cord wraps and uncoil the cables
prior to using the battery charger.
Extend the handle from the retracted position
by pulling it upward until it locks into place.
(Press the small silver buttons inward, if
necessary.)
WARNING!
Battery chargers may get hot during operation. DO NOT set charger on flammable materials
like carpeting, upholstery, paper, cardboard, etc. Charger may damage leather and plastic.
FPO

Related product manuals