(4). Position the Motomaster® Eliminator Power Pack on a flat, stable surface near the
battery and away from all moving parts of the engine. Ensure that the Boosting Power
Switch is in the "OFF" position.
(5). Connect the red positive (+) clamp of the cables to the positive (+) terminal of the
engine battery. The battery's positive terminal is usually larger in diameter than the negative
terminal. In most vehicles, the battery's positive terminal has a red wire connected to it.
(6). Connect the black negative
H
clamp of the cables to the chassis of the vehicle. If the
Red Boosting Connection LED illuminates and the Motomaster® Eliminator Power Pack's
alarm sounds, reverse polarity has been detected. Correct polarity must be established
before proceeding. Disconnect the boosting clamps from the vehicle's battery and repeat
steps (5) and (6) in this procedure. If no alarm sounds and the Green Boosting Connection
LED is illuminated, then proceed to the next step.
(7). Switch ON the boosting power switch. Before starting the engine, make sure the
Motomaster® Eliminator Power Pack and the cables are clear of belts and fans.
(8). Crank the engine for 4-5 seconds or until it starts, whichever is first.
~WARNING: Fire hazard
Do not crank the engine for more than 5 seconds. The jumpstart feature is designed for
short term operation only. Operating the boosting feature for more than 5 seconds may
cause damage to the unit. Allow the Power Pack to cool down for at least 3 minutes after
each boost.
(9). Switch OFF the Boosting Power Switch.
(10). Remove the red positive (+) clamp and then the black negative (-) clamp from the
vehicle.
(11). Store the boosting clamps in the appropriate holder on each side of the Motomaster® '
Eliminator Power Pack.
Important: Recharge the Motomaster® Eliminator Power Pack as soon as possible after
each use. See "Recharging the Power Pack Battery" section.
Connecting to an External Battery
You can extend battery operating times by connecting the Motomaster® Eliminator Power
Pack to a larger external battery.
~ WARNING: Fire hazard
Never allow the boosting cable's red and black clamps to touch each other or another
common metal conductor. This could cause damage to the unit and/or create a
sparking/explosion hazard.
14.
To Next Page
Loading...