- LhWARNING:
Fire Hazard
The boosting feature is designed for short term operation only- less than 5 seconds.
Operating the jumpstart feature for more than 5 seconds may cause damage to the unit.
Allow the Motomaster® Eliminator Power Pack to cool down for at least 3 minutes after
each boost.
LhCAUTION:
Equipment Damage
Do not connect any AC appliance with a neutral conductor connected to ground to the
Motomaster® Eliminator Power Pack.
LhCAUTION:
Equipment Damage
Do not expose the Motomaster® Eliminator Power Pack to temperatures over 104°F
(40°C).
Precautions when working with batteries
LhWARNING:
Explosion and Fire Hazard
1. Follow all instructions published by the battery manufacturer and the manufacturer of the
equipment in which the battery is installed.
2. Make sure the area around the battery is well ventilated.
3. Never smoke or allow a spark or flame within the vicinity of the engine or batteries.
4. Be careful not to drop a metal object on the battery. Do not allow a metal tool to
simultaneously touch the positive and negative cable ends or battery terminals. It can
create an explosion hazard.
5. Remove personal metal items such as rings, bracelets, necklaces and watches when
working with batteries. Batteries produce a short-circuit current high enough to weld a ring
or other similar objects to metal, causing a severe burn.
6.
If
you need to remove a battery, always remove the positive terminal from the battery
first. Make sure all accessories are off to avoid risk of hazard.
7. Make sure there is someone nearby in case of an emergency.
8. Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing
and eyes.
9. Wear complete eye and clothing protection. Avoid touching your eyes while working near
batteries.
10.
If
battery acid contacts skin or clothing, wash immediately with soap and water. If acid
enters your eyes, immediately flood them with cold running water for at least twenty
minutes and seek medical attention immediately.
4.
To Next Page
Loading...