What to do if my MotorGuide Tour has a loss of power?
If your MotorGuide Outboard Motor is losing power, several actions can be taken. First, remove the propeller and clean or replace it if needed. Also, recharge the battery and test it for a bad cell. Ensure you are using appropriate six-gauge wire. Finally, ensure that the propeller is clean.
Why is my MotorGuide Outboard Motor losing power?
A loss of power in your MotorGuide Outboard Motor can stem from several causes. It could be due to a weak battery. The propeller might be loose, damaged, or off-balance. Faulty wiring or electrical connections could also be the culprit, possibly due to insufficient wire gauge (six-gauge wire is recommended). Other potential causes include cracked or chipped magnets, which may cause a whining or grinding sound, or water intrusion in the lower unit.
General| Steering | Electric |
|---|---|
| Speed Control | Variable |
| Digital Guardian | Yes |
| Battery Indicator | Yes |
| Type | Electric |
Essential safety guidelines and precautions for operating the fishing motor.
Technical details including model, voltage, power output, and weight.
Guidelines for wiring, battery selection, and cable routing.
Diagram and instructions for connecting a 12-volt battery system.
Diagram and instructions for connecting a 24-volt battery system.
Details on clamp screws, tilt pin, depth collar, and steering tension adjustment.
Diagram and instructions for connecting a 36-volt battery system.
Guidance on selecting location and drilling holes for pontoon mount installation.
Step-by-step instructions for installing the pontoon mount securely.
Overview of standard and heavy-duty breakaway bow mounts.
Detailed instructions for mounting the bow mount bracket to the deck.
How to adjust the steering resistance on hand-operated bow mounts.
Proper procedure for setting the motor's depth in the water.
Instructions for raising and lowering the motor into stow or run positions.
How to interpret the directional indicator on the foot pedal.
Explanation of how to control motor speed using the foot pedal.
Understanding the different operational modes of the motor.
Steps for securely mounting the foot pedal to the boat deck.
Adjusting foot pedal resistance for optimal feel and performance.
Procedures for permanently attaching the foot pedal to the deck.
How to program and activate momentary buttons on the Tour ES model.
Identification and function of key components on the foot pedal and motor.
How to connect an optional Pinpoint sonar imaging display.
Instructions for stowing and deploying the motor.
Simple steps to power up the trolling motor.
Techniques for steering, including a 400-degree range tip.
How to operate the motor in momentary mode.
How to operate the motor in constant on mode.
Using the speed wheel to select desired speed from 1 to 10.
A quick reference for initial motor setup and calibration.
Important points to consider for successful motor calibration.
Steps to ensure the motor aligns correctly in the stow position.
How to set the motor to run straight ahead.
Procedure to recalibrate the foot pedal for full steering rotation.
Step-by-step guide for replacing a damaged or worn propeller.
Operator's duties for maintaining the motor and warranty coverage.
Guidelines for battery care and proper storage during freezing temperatures.
Identifies causes and solutions for a lack of motor power.
Addresses common causes of excessive noise or vibration from the motor.
Solutions for when the motor does not operate at any speed.
Identifies issues related to lost motor speeds.
Solutions for a stiff foot pedal or lack of full rotation.
Fixes for difficulty unlatching the mount from run or stow positions.
How to find authorized service centers for repairs.
Information on obtaining replacement parts and necessary details.
Details on the length of warranty coverage for recreational and commercial use.
Requirements that must be met to obtain warranty service.
Procedures for submitting warranty claims and obtaining service.
Exclusions from warranty coverage, including routine maintenance and damage.
Legal disclaimers, limitations on implied warranties, and exclusions.
Instructions and importance of registering the product for warranty validation.
To Next Page
