To Change the Network Name and Password
For the 5 GHz band:
1 Select and delete the old Network Name, then type in the new Network
Name.
2 Click the Save button.
3 You can click the Show Key box to check your typing for Password.
4 Select and delete the old Password, then type in the new Password.
5 Click the Save button.
For the 2.4 GHz band:
6 Select and delete the old Network Name, then type in the new Network
Name.
7 Click the Save button.
8 You can click the Show Key box to check your typing for Password.
9 Select and delete the old Password, then type in the new Password.
10 Click the Save button.
Network Name can be from 6 - 32 characters long. You can use the upper and lower
case letters (a – z and A – Z), numbers (0 - 9) and special characters (e.g. $_/& etc.)
except the single quote ‘ .
Password can be from 8 - 63 characters long. You can use upper and lower case
letters (a – z and A – Z), numbers (0 - 9) and special characters (e.g. $_/& etc.) except
the single quote ‘ .
Be sure to write down and save the new wireless network names and passwords
in a place where you can easily find it. One approach is to write them on a small
piece of paper and tape it on the bottom of your cable modem. Some people like
to take a picture of the settings with their phone, which is fine as long as long as
they save it in a place where they are sure to find it when they need it.
Wireless Guest Networks
To Next Page
Loading...
