Select the tab for the band you want to scan, 2.4 GHz or 5 GHz. Then click the
“Scan Wireless APs” button at the bottom of the page. This will pop up the
wireless Scan Results table:
Note that as in these sample Scan Results, you may need to scroll down to see all
neighboring networks.
For the 2.4 GHz band:
Look at the Channel column. This shows the channels that your neighboring
networks use. Available channels are 1 through 11. Many installations use only
channels 1, 6 or 11, because ideally wireless devices should be separated by 5
channels.
If there are very few neighboring wireless devices in your location, you should
To Next Page
Loading...
