When you have completed all Blacklists, remember to Enable Parental Control at the top
of the page, and click Save.
Setting up a Whitelist
Before you make any changes, make sure Parental Control at the top of the page
is Disabled, and click Save if you had to change this.
Under the tab List of Blocked Addresses (Whitelist), click the Add button to the
right. A set of fields will appear. Give your Whitelist a name, and then type in the
MAC Address of the device you want your Whitelist to apply to. Use the format
XX:YY:ZZ:WW:VV:UU.
Next, enter the URL of the first domain that you want to allow, for example Jill
_Site_1.com.
If you want to the Whitelist to apply only during certain hours, enter the start and
stop times for the period you want the Whitelist to apply. If you want the Whitelist
to apply always, make sure to set the start time to 12:00 am and the end time to
11:59 pm.
Next, select which protocols the Whitelist should apply to. If you’re not sure, leave
this selection at the default setting, BOTH.
Finally, make sure to check the Enable box, and click the Save button.
To Next Page
Loading...
