Motorola ACE3600 RTU - Page 215

Expansion Module
17-14
Table 17-2 Expansion Module - Error Code Display on LEDs
LEDs Location LED Error Code Description
Ethernet LEDs
in Expansion
Module
X1
X2
X4
X8
EXP
ADDR
ERR Code 1
Invalid ID in expansion module, or incompatible
board type.
ERR Code 2
Timeout getting discovery response.
ERR Code 3
Failed sending discovery request or getting
invalid response.
ERR Code 4
Failed to configure expansion port.
ERR Code 5
Timeout getting image.
ERR Code 6
Failed to initialize image.
ERR Code 7
Timeout initializing expansion module (while
getting ready.)
ERR Code 8
Received illegal file.
ERR Code 9
Failed to burn file.
ERR Code 10
Failed to read local I/O, or to send it to main
CPU.
ERR Code 11
Failed to send READY or START signal.
ERR Code 12
Timeout getting EMI 'Connect' after EMI was
started.
ERR Code 13
Failed a few times to send/connect keepalive
signal.
ERR Code 14
Failed to start EMI or disconnected due to 'fail
timeout'.
ERR Code 15
Other system startup failure.