Audio Control and Tone (ACT) Module
23-11
4) Press the PB to select the audio cell (from a selection of eight) to which you want to
record. (The audio signal number is displayed as a binary number represented by four
LEDs).
5) Start playing the audio. The unit will identify the input as audio and start recording.
The LEDs will start to blink and will stop when audio input ceases (or when the maximum
recording time has elapsed).
6) Repeat steps 4 and 5 to record additional audio signals (up to eight).
7) When recording is completed, all the LEDs will turn off.
To Next Page
Loading...
