Motorola APX 1500 - Page 118

Option Actions
Editing Channel Name
a To find <chan name>, press the Left or
Right navigation button.
b To change the name of the selected
channel, press EDIT.
c Use the keypad to enter alphanumeric
characters for the channel name.
Editing Zone Name
a To find <zone name>, press the Left or
Right navigation button.
b To change the name of the selected
zone, press EDIT.
c Use the keypad to enter alphanumeric
characters for the zone name.
Setting Zone Password Protection On or Off
a To find Protect, press the Left or Right
navigation button.
b To change the protection status of the
selected FPP-Enabled zone, press EDIT.
c To switch between password protection
on/off for the selected FPP-Enabled
zone, press the Up or Down navigation
button.
Editing the Talkgroup
a To find the Talkgroup, press the Left or
Right navigation button.
b To change the talkgroup of the current
channel, press EDIT.
c To edit the talkgroup ID or alias of the
current talkgroup, use the numeric key-
pad.
2 Press OK.
3 To return to the channel selection menu, press DONE.
NOTE:
Select a Tx PL or Rx PL frequency of zero for Carrier Squelch operation.
Tx Type becomes editable only when Rx Type is set to MIXED and a DVRS Convention
System is not referenced, otherwise it is set to the same mode as Rx Type.
To edit Tx PL, Rx PL, Tx DPL, and Rx DPL, the PL Setting must be set to Disabled.
If the PL setting is set to ALL, Rx or Tx, there is no Edit selection available to change
the codes for Tx PL, Rx PL, Tx DPL, or Rx DPL.
If the PL setting is set to Rx, you can only edit Tx PL and Tx DPL codes.
If the PL setting is set to Tx, you can only edit Rx PL and Rx DPL codes.
68012006035-FA
Chapter 33 : Front Panel Programming
118