September 9, 2011 68009482001
5-4 Maintenance: Assembly and Disassembly Procedures
5.2.2.3 Replacing the Control Head (O5)
1. Insert the Control Head in the Front of the Panel Assembly.
2. Use a T25 TORX™ driver bit to insert two screws (B) as shown in Figure 5-2.
5.2.2.4 Replacing the Front Panel
1. With the Front Panel Assembly hanging forward plug in all cables that connect the front panel
assembly and control head to the mobile radio and Consolette main board.
2. Reposition the front panel onto the chassis and install the two screws (A) on the bottom of the
front panel assembly as shown in Figure 5-2 using a T25 TORX™ driver.
3. Tighten the screws to 1.5 N-m.
5.2.3 Main Board
5.2.3.1 Removing the Main Board
1. Unplug all cables and flex cables.
2. Remove the eight screws (A) on the main board assembly as shown in Figure 5-3 using a
T15 TORX™ driver.
3. Store the main board assembly in anti-static bag when it is not being serviced.
Figure 5-3. Removing and Replacing Main Board
Screw (A)
Screw (A)
Locating
Pin
Locating
Pin
To Next Page
Loading...
