68009482001 September 9, 2011
Troubleshooting Charts and Error Codes Troubleshooting Charts 7-39
O5 Display Error Codes
Auxiliary Display Error Codes
NOTE: For Limited Front Panel models, customer may optionally connect a O5 CH to the unit in order
to get the detailed error code..
NOTE: If error(s) continues, contact an approved service shop for further repair
O5 Display Text Trigger Event Troubleshooting Recommendation
ERROR 1C/02 Consolette operation is enabled in a non
L30 model Codeplug
Replace transceiver with a L30 model transceiver
for full support of Consolette functionality.
ERROR 1C/10 Consolette Controller board did not report
at power up. This is a Consolette fatal
error.
Check cable connections between Consolette
controller board and the transceiver. Try
reprogramming the Consolette Controller card.
Other errors Various Refer to the O5 user's guide for a list of radio
errors and recommendations.
Auxiliary Display Text Trigger Event Troubleshooting Recommendation
FL 1C/00
Unknown Error
Unknown error failure Using Flashport, reprogram the Consolette
controller board.
FL 01/90
Radio Comm Error
Consolette to Radio CAN Communication
failure
Check cable connections between Consolette
controller board and the transceiver.
CH ID # ERR Duplicate Device ID Detected Cycle power on the Consolette.
FL 1C/81
Host Checksum Error
Host Flash Checksum failure Using Flashport, reprogram the Consolette
controller board.
FL 1C/82
FLASH Driver Error
Flash Driver failure Using Flashport, reprogram the Consolette
controller board.
FL 1C/83
FLASH Table Error
PSDT Validate failure Using Flashport, reprogram the Consolette
controller board.
FL 1C/84
FLASH Mount Error
ISH Manager Initialization failure Using Flashport, reprogram the Consolette
controller board.
FL 1C/85
FPGA Image Error
PSDT Nautilus Image Record not found Using Flashport, reprogram the Consolette
controller board.
FL 1C/86
FPGA Init Error
Nautilus Image Programming failure Using Flashport, reprogram the Consolette
controller board.
FL 1C/91
DSP Image Error
DSP initialization fails (Flash Checksum
failure, PSDT Record not found, or Record
Size too big)
Using Flashport, reprogram the Consolette
controller board.
FL 1C/92
DSP Failure
Host to DSP (IPC) Communication failure
or DSP unresponsive
Using Flashport, reprogram the Consolette
controller board.
FL 1C/A1
Codeplug Error
Code Plug Record not found or corrupted Using Flashport, reprogram the Consolette
controller board.
FL 1C/A2
Tune Data Error
Secure Tune checksum error Using Flashport, reprogram the Consolette
controller board.
Radio Error Mobile radio errors Refer to the O5 user's guide for a list of radio
errors and recommendations.
Device Error Non-radio errors Refer to the O5 user's guide for a list of radio
errors and recommendations.
To Next Page
Loading...
