September 9, 2011 68009482001
5-2 Maintenance: Assembly and Disassembly Procedures
5.2.1 Top Cover
5.2.1.1 Removing the Top Cover
1. Remove the four screws (A) that retain the cover to the housing as shown in Figure 5-1 using
a T25 TORX™ driver.
2. Slide the top cover towards the rear and then lift the top cover straight up to remove.
Figure 5-1. Removing and Replacing the Top Cover
5.2.1.2 Replacing the Top Cover
1. Lower the top cover straight down onto the base.
2. From the rear, slide the top cover forward making sure the front lip goes under the front
plastic.
3. Install the four screws (A) on the top cover as shown in Figure 5-1 using a T25 TORX™
driver.
4. Tighten the screws to 1.5 N-m.
NOTE: It is assumed from this point on that all disassembly and reassembly procedures begin with
the top cover removed and end with the top cover being replaced.
Screw (A)
Screw (A)
To Next Page
Loading...
