68009482001 September 9, 2011
Maintenance: Assembly and Disassembly Procedures 5-3
5.2.2 Front Panel
5.2.2.1 Removing the Front Panel
1. Remove the two screws (A) on the bottom of the front panel assembly as shown in Figure 5-2
using a T25 TORX™ driver.
2. Unplug all cables connected to the front panel assembly and control head to the mobile radio
and Consolette main board.
NOTE: The front panel Flex cables should be removed at the Consolette main board end.
NOTE: With the front panel assembly free from the rest of the Consolette chassis the Keypad board,
Display board and Speaker can be easily removed and replaced using a T15 TORX™ driver.
5.2.2.2 Removing the Control Head (O5)
1. Use a T25 TORX™ driver bit to remove two screws (B) as shown in Figure 5-2.
2. Remove the Control Head from the Front of the Panel Assembly.
Figure 5-2. Removing and Replacing the Control Head
Cables to
unplug
Cables to
unplug
Screw (B) Screw (A)
To Next Page
Loading...
