Find it: Menu > Settings > Wireless
& networks > Bluetooth settings
To connect with a new device, you need to
pair with it. You only need to do this once
for each device—to connect again, just
turn on the device.
1.Make sure the device you are pairing
with is in discoverable mode.
Refer to the guide that came with the
device for details.
2.In Bluetooth settings, touch
Bluetooth to turn on and scan. If
Bluetooth power is already on, touch
Scan for devices.
3.Touch a device to connect.
4.If necessary, touch OK, or enter the
device passkey (like 0000) to connect to
the device. When the device is
connected, the Bluetooth indicator
appears in the status bar.
Note: Using a mobile device or accessory
while driving may cause distraction and
may be illegal. Always obey the laws and
drive safely.
After you connect:
• To reconnect with a device, turn on the
device or touch the device name in the
Bluetooth devices list.
• To disconnect a device, turn off the
device or touch the device name in the
To Next Page
Loading...
