AP_CMM2 User Manual Pa
e 48 of 49
SPECIFICATIONS
ACCESS POINT MODULE
Operating Frequency Range U-NII: 5.25 to 5.35 GHz and 5.725 to 5.825 Ghz
ISM: 5.725 to 5.850 GHz
Access Method TDD/TDMA
Signaling Rate 10 Mbps
Modulation Type High Index BFSK
(Optimized for interference rejection)
Carrier to Interference (C/I) 3dB nominal
Receiver Sensitivity -83dBm 10
-4
BER
Operating Range Up to 2 miles with integrated antenna in the 5.2
GHz band. Up to 10 miles with passive reflector
in the 5.7 GHz band.
Transmitter Power Meets FCC U-NII/ISM and IC LELAN ERP Limit
DC Power 0.3A @ 24 VDC (7.2 watts)
Interface 10/100 BaseT, half/full duplex
Rate auto negotiated (802.3 compliant)
Protocols Used by CANOPY IPV4, UDP, TCP, ICMP, Telnet,
HTTP, FTP, SNMP, DES
Protocols Supported by Canopy Switched Layer 2 Transport with support for all
common Ethernet protocols including IPV6,
NetBIOS, DHCP, IPX, etc.
Software Upgrade Path Remotely downloaded into flash memory
Network Management HTTP, TELNET, FTP, SNMP
Operation Temperature
-40°F to +131ºF (-40°C to +55°C)
Weight 1 lb. (.45kg)
Dimensions
11.75” H x 3.4” W x 3.4” D (29.9 cm H x 8.6 cm
W x 8.6 cm D)
To Next Page
Loading...
