October, 2004 6880309N15-A 2-3
CDM Control Station CDM Control Station Operation
Operator Instructions
button while speaking into the microphone. Release the but-
ton to listen. Transmission is accomplished by using one of
the following microphones:
• Desk Microphone
The Control Station is configured by default to use a
desk microphone. DIP switch 6 should be in the ON
position.
• Headset
The Control Station can be configured to operate
with a headset. DIP switch 7 should be in the ON
position.
• Internal Microphone
The Control Station comes equipped with an internal
microphone intended for use in low noise environ-
ments. The local microphone is active anytime the
front panel Transmit button is pressed. DIP switch 5
should be in the ON position.
To Next Page
Loading...
