Motorola CP100 - Programming Quick Reference; Channel and Tone Programming

CP100 Programming Quick Reference
Function Appearance
Press & hold
M
Qfor 3 sec. and turn on radio. k displays.
*Channel
Use [ or ] for 1 through 15.
Frequency
Press
\ until l displays. To
change, press
[ or ] .
*depending upon model
*depending upon model
Interference
Eliminator
Code
Appears after
l shows. Set
for each channel.
*Scramble
Code
Press \ until e displays. Must
be set to same code for all radios.
Bandwidth
Press \ until K displays. Press
[
or
]
to select D (25.0 kHz)
or C (12.5 kHz).
Note: If bandwidth is not flashing,
it is not selectable on the
chosen frequency.
2
1
e
K
C
QRC.fm Page 53 Friday, February 21, 2003 12:24 PM