Motorola CPEi 300 - Page 7

5
Desktop CPEi 300 User Guide
Caution: If the Power LED and all 3 WiMAX Signal Strength
LEDs are blinking, then a software upgrade is in progress. Do NOT
remove power to the CPE.
Note: If the Power LED is BLINKING and all 3 WiMAX Signal
Strength LEDs are OFF, the CPE device is overheating, and you
will not have service.
WAN WiMAX While acquiring access to the WiMAX
Network:
• The Power LED is ON.
• The WAN LED is OFF.
• All WiMAX Signal Strength
LEDs will be in vary between
ON, OFF and/or BLINKING
status.
Once connectivity to the WiMAX
Network is established:
• The Power LED is ON.
• The WAN LED is ON.
When WiMAX traffic is detected:
• The Power LED is ON.
• The WAN LED is BLINKING.