Diagnostics B
High-Definition DVR DCX3510-M • Installation Manual 89
365-095-17066-x.1
The DCX3510-M is in the interactive
initialization state and the TransMode
has stopped.
r dc RUN_WAIT_DC_OR_C The DCX3510-M is in the interactive
state and waiting for the default
configuration or the contention
channel list messages.
r RUNNING Interactive state is running, sending
idle messages, and waiting for any
prepare for poll or MAC messages.
S RUN_STOPPED The interactive run state has stopped
and DCX3510-M is waiting for status
or a transmission control message.
00 INVALID The interactive state is unknown or
invalid.
MAC Abort Cntr
This counter increments every time the MAC layer reaches the cell abort count
limit. It is reset by the successful upstream transmission of a cell: for example,
when the DCX3510-M receives an ACK. If the counter reaches the MAC abort
count limit, the DCX3510-M assumes the MAC layer is unavailable due to noise,
congestion, or some other problem. The DCX3510-M stops transmitting data
upstream, reports an error to the calling function, and attempts to re-enter the
network using the initialization process. 0000 is displayed as the default or the MAC
Abort CNTR is unconfigured or unknown.
Socket Port State
The socket mode and activity:
• UNUSED — The socket is not being used.
• OPENED — The socket is open.
• READY — The socket is ready to send or receive.
• RECEIVING — The socket is receiving data from the application server.
• SENDING — The socket is sending data to the application server.
• UNKNOWN — The socket state is invalid or unknown.
To Next Page
Loading...
