Remote Mounting 21
Installing and Connecting the MTM300
Transceiver Trunnion Installation
1. Using the trunnion bracket as a template, mark the positions of the holes on the
mounting surface (see Figure 20).
Use the innermost four holes for a curved
mounting surface, and
use the four outmost holes for a flat surface.
2. Centerpunch the spots you have marked and drill a 4 mm Ø hole at each mark.
3. Secure the trunnion mounting bracket with the four screws provided.
Transceiver Installation
1. Ensure that the plastic guides are aligned (horizontal) to the transceiver grooves.
2. Slide the transceiver grooves into the plastic guides until it snaps into place.
3. Secure the transceiver with the two wing screws provided.
Figure 20 Transceiver Trunnion Mounting
Thread Hole for
Wing Screw
Groove
Mounting Surface
Wing Screw
Tabs
Wing Screw
Trunnion
Plastic Guides
To Next Page
Loading...
