Remote Mounting 27
Speaker Installation and Connection
Introduction
The MTM300 ships standard with the external speaker. The speaker is supplied with an
accessory plug attached to its cable and a strain relief clip which is threaded over the cable
between the speaker and accessory plug.
Speaker Installation
1. Ensure that the place where you are going to install the speaker is within user’s reach
and that the speaker will not obstruct vehicle operation.
2. Loosen the two wing screws of the trunnion bracket and remove the speaker.
3. Using the trunnion bracket as template, mark the locations of the three mounting
holes.
4. Centerpunch and drill a 4 mm Ø hole at each location.
5. Mount the trunnion bracket with the screws supplied (see Figure 27).
6. Insert the speaker into the trunnion bracket and tighten the two wing screws.
Figure 27 Mounting Speaker under Dashboard
To Next Page
Loading...
