Motorola Dimetra MTM300 - Accessory Plug Removal; Speaker Connection; Figure 28 Disassembling and Reassembling Accessory Plug - Disassembly; Figure 29 Speaker Connection

28 Remote Mounting
Accessory Plug Removal
The accessory plug is not needed in case of remote mount installation.
1. Squeeze tabs together (see , A), and remove the cover from the accessory plug (see
Figure 28, B).
2. Using thumb pressure from the bottom of the shell, push the pin housing up and out
of the shell (see Figure 28, C).
3. Remove the speaker wires from the accessory plug.
Figure 28 Disassembling and Reassembling Accessory Plug - Disassembly
Speaker Connection
Connect the pins of the wires to the junction box terminals 1 and 2.
Figure 29 Speaker Connection
Tabs
Cover
(In Place)
A
Cover
(Removed)
B
Pin
Housing
13 Location Side
Flat Side
Shell
C
1
2
SPEAKER
JUNCTION BOX TERMINAL