17
Talking and Listening
Changing Interference Eliminator Code
If there is too much noise on a channel, try changing the interference eliminator code
to reduce the noise.
Do This Result
1. From Standby screen,
press
G three times.
Current interference eliminator code
flashes.
2. Press
Bor Cto change
code.
3. Press
Ato save code.
Display returns to Standby screen, showing
new code.
2
1
2
3
6881040B40a.book Page 17 Friday, July 12, 2002 11:46 AM
To Next Page
Loading...
