Motorola DS3508 - Stop Bit Select; Check Receive Errors

7 - 10 DS3508 Product Reference Guide
Stop Bit Select
The stop bit(s) at the end of each transmitted character marks the end of transmission of one character and
prepares the receiving device for the next character in the serial data stream. Select the number of stop bits (one or
two) based on the number the receiving terminal is programmed to accommodate. Set the number of stop bits to
match host device requirements.
Check Receive Errors
Select whether or not to check the parity, framing, and overrun of received characters. The parity value of received
characters is verified against the parity parameter selected above.
*1 Stop Bit
2 Stop Bits
*Check For Received Errors
Do Not Check For Received Errors