Motorola DS3508 - Setting Up the Digital Scanner

Getting Started 1 - 3
Setting Up the Digital Scanner
Installing the Interface Cable
1. Loosen the two screws on the cable clamp at the bottom of the scanner and gently pull the clamp away from
the bottom of the scanner.
Figure 1-2 Removing the Cable Clamp
2. Open the clamp and plug the interface cable modular connector into the cable interface port on the bottom of
the scanner handle.
Figure 1-3 Inserting the Interface Cable
3. Gently tug the cable to ensure the connector is properly secured.
NOTE Different hosts require different cables. The connectors illustrated in each host chapter are examples only.
Connectors vary from those illustrated, but the steps to connect the digital scanner are the same.