Motorola DS3508 - Appendix A Standard Default Parameters; User Preferences

Appendix A Standard Default Parameters
Table A-1 Standard Default Parameters Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter Set Defaults 4-5
Parameter Bar Code Scanning ECh Enable 4-6
Decode Pager Motor Enable F1h 65h Enable 4-7
Decode Pager Motor Duration F1h 72h 500 msec 4-7
Trigger Mode 8Ah Level (Standard) 4-9
Beep After Good Decode 38h Enable 4-11
Beeper Tone 91h Medium 4-12
Beeper Volume 8Ch High 4-11
Beeper Duration F1 74h Medium 4-13
Suppress Power-up Beeps F1h D1h Do Not Suppress 4-13
Hands-Free Mode F1h 76h Enable 4-14
Presentation Performance Mode F1 8Ah Standard 4-14
Time Delay to Presentation Idle Mode F1 97h 1 Minute 4-16
Time Delay to Presentation Sleep Mode F1 96h 1 Hour 4-18
Low Power Mode 80h Disable 4-20
Time Delay to Low Power Mode 92h 1 Hour 4-21
Fuzzy 1D Processing F1h 02h Enable 4-23
1
User selection is required to configure this interface and this is the most common selection.