User Preferences & Miscellaneous Digital Scanner Options 4 - 31
Hands-Free Decode Aiming Pattern
Parameter # F1h, 4Eh
Select Enable Hands-Free Decode Aiming Pattern to project the aiming pattern during bar code capture,
Disable Hands-Free Decode Aiming Pattern to turn the aiming pattern off, or Enable Hands-Free Decode
Aiming Pattern on PDF to project the aiming pattern when the digital scanner detects a 2D bar code.
This parameter does not apply to Snapshot Mode. See Operational Modes on page 5-4.
NOTE With Picklist Mode on page 4-24 enabled, the decode aiming pattern flashes even when the Decode
Aiming Pattern is disabled.
Enable Hands-Free Decode Aiming Pattern
(01h)
Disable Hands-Free Decode Aiming Pattern
(00h)
*Enable Hands-Free Decode Aiming Pattern on PDF
(02h)
NOTE Picklist Mode temporarily overrides the Disable Decode Aiming Pattern parameter. The Decode Aiming
Pattern cannot be disabled (using the DS3508-SR and DS3508-ER configurations) when the following
parameters/settings are selected:
• Smart LED Mode is set to Enable (DS3508-ER configuration)
• Focus Mode is set to Auto-Ranging (DS3508-ER configuration)
• Picklist Mode is set to Enable (DS3508-ER and DS3508-SR configurations)
To Next Page
Loading...
