10 - 6 ET1 Enterprise Tablet User Guide
A message appears
stating not enough
storage memory.
Too many
applications installed
on the ET1.
Remove user-installed applications on the ET1 to recover
memory. Select > Settings > Applications > Manage
Applications. Select the unused programs and touch
Uninstall.
The ET1 does not
decode when reading
bar code.
DataWedge is not
enable.
Ensure that DataWedge is enabled and configured properly.
Refer to the ET1 Enterprise Tablet Integrator Guide for more
information.
Unreadable bar
code.
Ensure the symbol is not defaced.
Distance between
the ET1 and bar
code is incorrect.
Place the ET1 within proper scanning range.
ET1 is not
programmed for the
bar code type.
Program the ET1 to accept the type of bar code being
scanned. Refer to the ET1 Enterprise Tablet Integrator Guide
for DataWedge configuration.
ET1 is not
programmed to
generate a beep.
If the ET1 does not beep on a good decode, set the
application to generate a beep on good decode.
ET1 cannot find any
Bluetooth devices
nearby.
Too far from other
Bluetooth devices.
Move closer to the other Bluetooth device(s), within a range
of 10 meters (30 feet).
The Bluetooth
device(s) nearby are
not turned on.
Turn on the Bluetooth device(s) to find.
The Bluetooth
device(s) are not in
discoverable mode.
Set the Bluetooth device(s) to discoverable mode. If needed,
refer to the device’s user documentation for help.
Table 10-1
Troubleshooting the ET1 Enterprise Tablet (Continued)
Problem Cause Solution
To Next Page
Loading...
