Motorola g20 - Table 50. +CNMI Parameters

AT Commands Reference
126 98-08901C68-O
Read Command
Test Command
The following table shows the +CNMI parameters.
Example
AT+CNMI=?
+CNMI: (0,3),(0-2),(0,2),(0),(0)
OK
Command Response/Action
+CNMI? +CNMI:<mode>,<mt>,<bm>,<ds>,<bfr>
Command Response/Action
+CNMI=? +CNMI: (list of supported <mode>s), (list of supported
<mt>s), (list of supported <bm>s), (list of supported
<ds>s), (list of supported <bfr>s)
Table 50. +CNMI Parameters
<Parameter> Description
<mode> 0 Buffer unsolicited result codes in the g20
3 Forward unsolicited result codes directly to the
terminal
<mt> 0 No SMS-DELIVER indications are routed to the
terminal
1 If SMS-DELIVER is stored in the g20, the memory
location indication is routed to the terminal using the
unsolicited result code: +CMTI: <mem>,<index>
2 SMS-DELIVER is routed directly to the terminal using
the unsolicited result code:
+CMT:<oa>,[<alpha>],<scts>[,<tooa>,<fo>,<pid>,
<dcs>,<sca>,<tosca>,<length>]<CR><LF><data>
<bm> 0 No CBM indications are routed to the terminal
2 New CBMs are routed directly to the terminal using the
unsolicited result code:
+CBM: <sn>,<mid>,<dcs>,<page>,<pages><CR>
<LF><data>
Note: The CBM of "multipage" SM and "Quick view" are not
supported.
<ds> 0 No SMS-STATUS reports are routed to the terminal
<bfr> 0