98-08901C68-O 133
AT Commands Reference
4.5.1.15 +CMSS, Send Message From Storage
This command sends a pre-stored message. The DA (destination address) parameter is optional. If a DA is given, the message
is sent to that address. Otherwise the message is sent to the DA it was stored with (using command +CMGW). If no DA is found,
an error occurs.
Set Command
The Set command sends a message from storage to the network.
Read Command
The Read command for +CMSS is not defined by ETSI, and therefore is not supported by the g20. The g20 returns an error.
Test Command
The Test command for +CMSS is not defined by ETSI, and therefore is not supported by the g20. The g20 returns an error.
The following table shows the +CMSS parameters.
Example
AT+CMSS=7
+CMSS: 12
OK
AT+CMSS=7,"054565132",129
+CMSS: 13
OK
Note
In all cases of network failure, the error "invalid destination address" is returned.
Command Response/Action
+CMSS=<index>[,<da>[,<toda>]] +CMSS: <mr>[,<scts>]
or:
+CMS ERROR: <err>
Table 56. +CMSS Parameters
<Parameter> Description
<index> Index in the SMS memory of the message to be sent
To Next Page
Loading...
