Motorola g20 - Table 64. +CBC Parameters

AT Commands Reference
146 98-08901C68-O
The following table shows the +CBC parameters.
Example
at+cbc
+CBC: 0,60 //This example shows 0 (battery powered) with 60% power.
OK
4.7.1.2 +CBAUD, Baud Rate Regulation
This command sets the request baud rate. The baud rate of the g20 is changed/set to the request value <rate> written in the
command.
Specifying a value of 9 disables the function and allows operation only at rates automatically detectable by the g20. The
specified rate takes effect following the issuing of any result code(s) associated with the current command line.
The UART is configured according to the request, or to the specific constant baud rate or auto baud rate after output "OK"
response to the terminal. For example, AT+CBAUD=8 is equivalent to AT+CBAUD=57600. Using AT+CBAUD with the
<rate> value other than 9 disables the auto baud rate detection feature. The g20 supports up to 115200 auto baud.
Set Command
Table 64. +CBC Parameters
<Parameter> Description
<bcs> Battery status values
0 Battery powered
1 Externally powered, battery connected
2 Externally powered, no battery connected
3 Invalid power supply
Note: The g20 input power source is connected via the
battery pins.
<bcl> Battery Charge level
0 Indicates no battery
1-100 Indicates percentage of charge remaining
Note
The g20 does not allow the detection of battery use. The power supply of the g20 is connected via the battery pins.
However, users can use this command to verify the level of the g20 input power source.
Command Response/Action
AT+CBAUD=<n>
AT+CBAUD=<rate>
OK
or:
ERROR