Motorola g20 - Table 67. &K Parameters

98-08901C68-O 151
AT Commands Reference
Set Command
Read Command
Test Command
The following table shows the &K parameters.
Example
AT&K?
&K:3
OK
AT&K4
OK
4.7.1.8 +IPR, Local DTE-DCE Serial Port Rate
This command is responsible for setting and saving the request baud rate. This numeric extended-format parameter specifies the
data rate at which the g20 accepts commands. Specifying a value of 9 disables the function and allows operation only at rates
automatically detectable by the g20. The specified rate takes effect following the issuing of any result code(s) associated with
the current command line.
Command Response/Action
AT&K<param> OK
Command Response/Action
AT&K? &K: <param>
Command Response/Action
AT&K=? &K: (list of supported <param>s)
Table 67. &K Parameters
<Parameter> Description
<param> 0 Disable all DTE/DCE flow control
3 Enable CTS/RTS DTE/DCE flow control
4 Enable Xon/Xoff DTE/DCE flow control
5 Enable Xon/Xoff DTE/DCE flow control
6 Enable CTS/RTS DTE/DCE flow control
The default value is 3.