Motorola g20 - Table 76. +MAPATH Parameters

AT Commands Reference
164 98-08901C68-O
Read Command
The Read command returns the active input audio accessory and the output accessory for each feature.
Test Command
The Test command returns the supported audio directions (input/output), accessories and features.
The following table shows the +MAPATH parameters.
Command Response/Action
+MAPATH? +MAPATH:1(mode in),<accy>
+MAPATH:2(mode out), <accy>,<feature1>
+MAPATH:2(mode out), <accy>,<feature2>
+MAPATH:2(mode out), <accy>,<feature4>
+MAPATH:2(mode out), <accy>,<feature8>
OK
Command Response/Action
+MAPATH=? +MAPATH: (list of supported directions),(list of
supported accessories),(list of supported features
combinations)
OK
Table 76. +MAPATH Parameters
<Parameter> Description
<direct> 1 Mode in, field <features> are ignored.
2 Mode out, field <features> are present.
<accy> Mode in:
1Mic
2 Headset mic
3 Digital RX
Mode out: (1-4)
1 Speaker
2 Headset speaker
3 Alert speaker, for example, battery low, incoming
SMS, power up, and so on.
4 Digital TX
<features> (1-15) 1 Voice
2 Key feedback
4Alert
8Ring