Motorola g20 - Page 179

98-08901C68-O 165
AT Commands Reference
Example
AT+MAPATH=1,2 //Direct=1 (input), accy=2 (headset mic)
OK
AT+MAPATH=2,1,3 //Direct=2 (output), accy=1 (speaker), feature=1 (voice and keypad)
OK
AT+MAPATH? //Set the headset mic as the input accessory
MAPATH: 1,2 //Direct=1 (input), accy=2 (headset mic)
//Set the speaker as the output accessory for voice
MAPATH: 2,1,1 //Direct=2 (output), accy=1 (speaker), feature=1 (voice)
//Set the speaker as the output accessory for keypad
MAPATH: 2,1,2 //Direct=2 (output), accy=1 (speaker), feature=2 (keypad)
//Set the alert speaker as the output accessory for alert & ring
MAPATH: 2,3,12 //Direct=2 (output), accy=3 (alert speaker), feature=12 (alert + ring)
OK
AT+MAPATH=?
+MAPATH: (1,2),(1-4),(1-15)
OK
4.8.2.2 +MAVOL, Volume Setting
This command enables you to determine a volume level for a particular feature in a particular accessory. The gain levels are
saved. Therefore, upon power up, the path active (mic, speaker and alert speaker) will have these saved gain levels.
Set Command
The Set command sets the volume level <n> to a certain <feature> through a certain <accy>.
Command Response/Action
+MAVOL=<accy>,<feature>,<vol> OK
or:
+CME ERROR: <err>