Motorola g20 - Table 88. X Parameters

AT Commands Reference
186 98-08901C68-O
The following table shows the X parameters.
Example
ATX?
0
OK
ATX1
OK
4.10.1.5 S, Bit Map Registers
This command reads/writes values of the S-registers. The g20 supports this command for various S values, according to official
specifications (ITU-I, ETSI, or manufacturer specific).
Table 88. X Parameters
<Parameter> Description
<value> 0 CONNECT result code given upon entering online
data state:
Dial tone detection Disabled
Busy detection Disabled
1 CONNECT <text> result code given upon entering
online data state:
Dial tone detection Disabled
Busy detection Disabled
2 CONNECT <text> result code given upon entering
online data state:
Dial tone detection Enabled
Busy detection Disabled
3 CONNECT <text> result code given upon entering
online data state:
Dial tone detection Disabled
Busy detection Enabled
4 CONNECT <text> result code given upon entering
online data state:
Dial tone detection Enabled
Busy detection Enabled
The default value is 4.