Motorola g20 - Table 95. +CMEE Parameters

AT Commands Reference
198 98-08901C68-O
The following table shows the +CMEE parameters.
Table 95. +CMEE Parameters
<Parameter> Description
<n> 0 Disable the +CME ERROR: <err> result code and
use ERROR.
1 Enable the +CME ERROR: <err> result code and
use numeric <err> values.
2 Enable +CME ERROR: <err> result code and use
verbose <err> values.
The default value is 0.
<err> Numeric format followed by verbose format:
0 Phone failure
1 No connection to phone
2 Phone-adaptor link reserved
3 Operation not allowed
4 Operation not supported
5 PH-SIM PIN required
6 PH-FSIM PIN required
7 PH-FSIM PUK required
10 SIM not inserted
11 SIM PIN required
12 SIM PUK required
13 SIM failure
14 SIM busy
15 SIM wrong
16 Incorrect password
17 SIM PIN2 required
18 SIM PUK2 required
20 Memory full
21 Invalid index
22 Not found
23 Memory failure
24 Text string too long
25 Invalid characters in text string
26 Dial string too long
27 Invalid characters in dial string
30 No network service
31 Network timeout
32 Network not allowed - emergency calls only
40 Network personalization PIN required
41 Network personalization PUK required
42 Network subset personalization PIN required
43 Network subset personalization PUK required
44 Service provider personalization PIN required
45 Service provider personalization PUK required
46 Corporate personalization PIN required