Motorola g20 - Table 97. +MHIG Parameters

98-08901C68-O 203
AT Commands Reference
Set Command
The Set command sets the ignition state.
The following table shows the +MHIG parameters.
Example
AT+MHIG=1
OK
4.11.1.2 +CKPD, Keypad Control
This command enables the emulated pressing of keys, or virtual keycodes, as if entered from the g20 keypad or from a remote
handset. These virtual keycodes, (listed in Table 99, “Character Codes” on page 204), may not be supported by all members of
the g20 product family. If a key is not supported by the g20, the g20 returns +CME ERROR: indicating that error 25 (Invalid
character) has occurred.
This command is provided primarily to support test efforts, and to allow the emulation of a handset device by a peripheral. This
command is not intended to be used by accessory devices to access items within the g20 menus. In order to preserve the
compatibility across the g20 product family, you should use the commands intended for manipulating features for this purpose.
Set Command
Command Response/Action
+MHIG=<state> OK
Table 97. +MHIG Parameters
<Parameter> Description
<state> 0 Ignition Off
1 Ignition On
Note
The +CKPD command does not support DTMF tones.
Command Response/Action
+CKPD=<keys>[,<time>[,<pause>]] OK
or:
+CME ERROR: <err>