Motorola g20 - Table 101. +CMER Parameters

AT Commands Reference
208 98-08901C68-O
The following table shows the +CMER parameters.
Example
For g18 compatible
AT+CMER=?
+CMER: (00),(00,01,02),(00),(00),(00)
For g20
AT+CMER=?
+CMER: (0,1),(0,1,2),(0),(0),(0)
AT+CMER?
+CMER: 00,00,00,00,00
AT+CMER=0,2, 0, 0, 0
OK
Table 101. +CMER Parameters
<Parameter> Description
<mode> Controls the processing of unsolicited result codes
specified within this command.
0 Buffer unsolicited result codes in the g20.
1 Discard unsolicited result codes in online mode. Only
in g18 compatible. The g20 supports only 0.
The default value is 0.
<keyp> 0 Do not report keypad events.
1 Keypad event reporting using result code +CKEV.
Only keypad events which are not caused by the
+CKPD commands are reported.
2 Keypad event reporting using result code +CKEV.
All keypad events, including key pressings caused by
the +CKPD commands, are reported.
The default value is 0.
<disp> 0 Do not report display events.
The default value is 0.
<ind> 0 Do not report indicator events.
The default value is 0.
<bfr> Controls the effect on buffered codes when <mode> 1, 2 or
3 is entered.
0 Clear buffer.
The default value is 0.