Motorola g20 - Table 105. +CGDCONT Parameters

98-08901C68-O 213
AT Commands Reference
Read Command
The Read command returns the current settings for each defined context.
Test Command
The Test command returns the values supported as a compound value. If the MT supports several PDP types, <PDP_type>, the
parameter value ranges for each <PDP_type> are returned on a separate line.
The following table shows the +CGDCONT parameters.
Command Response/Action
AT+CGDCONT? +CGDCONT:
<cid>,<PDP_type>,<APN>,<PDP_addr>,
<data_comp>,<head_comp>[,<pd1>[,…[,pdN]]][<CR>
<LF>+CGDCONT:
<cid>,<PDP_type>,<APN>,<PDP_addr>,<data_comp
>,<head_comp>[,<pd1>[,…[,pdN]]][...]]
Command Response/Action
AT+CGDCONT=? +CGDCONT: (range of supported <cid>s),
<PDP_type>,,, (list of supported <d_comp>s),(list of
supported <h_comp>s)[,(list of supported <pd1>s)
[,…[,(list of supported <pdN>s)]]]
[<CR><LF>+CGDCONT: (range of supported
<cid>s),<PDP_type>,,,(list of supported <d_comp>s),
(list of supported <h_comp>s)[,(list of supported
<pd1>s)[,…[,(list of supported <pdN>s)]]][...]]
Table 105. +CGDCONT Parameters
<Parameter> Description
<cid> Numeric parameter specifying a particular PDP context
definition (PDP Context Identifier). The parameter is local
to the Terminal-Mobile Terminal interface and is used in
other PDP context-related commands.
The Test command returns the range of permitted values
(minimum value=1).
The default value is 0.
<PDP_type>
(Packet data
protocol type.)
String parameter specifying the type of packet data
protocol:
X25 ITU-T/CCITT X.25 layer 3
IP Internet Protocol (IETF STD 5)
OSPIH Internet Hosted Octet Stream Protocol
PPP Point to Point Protocol (IETF STD 51)
If the MT supports several PDP types, the parameter value
ranges for each <PDP_type> are returned on a separate
line.