Motorola g20 - Table 106. +CGQMIN Parameters

98-08901C68-O 217
AT Commands Reference
The following table shows the +CGQMIN parameters.
Example
AT+CGQMIN=?
+CGQMIN: (1-3),(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
AT+CGQMIN?
+CGQMIN: 1,2,4,3,9,10
+CGQMIN: 2,2,4,3,9,10
+CGQMIN: 3,2,4,3,9,10
OK
4.12.1.4 CGQREQ, Quality of Service Profile (Requested)
This command enables the terminal to specify a Quality of Service Profile that is used when the MT sends an Activate PDP
Context Request message to the network.
Set Command
The Set command specifies a profile for the context identified by the (local) context identification parameter, <cid>. As this is
the same parameter that is used in the +CGDCONT command, the +CGQREQ command is effectively an extension of the
+CGDCONT command. The QoS profile consists of a number of parameters, each of which may be set to a separate value.
Table 106. +CGQMIN Parameters
<Parameter> Description
<cid> A numeric parameter that specifies a particular PDP
context definition.
<precedence> A numeric parameter that specifies the precedence class.
<delay> A numeric parameter that specifies the delay class.
<reliability> A numeric parameter that specifies the reliability class.
<peak> A numeric parameter that specifies the peak throughput
class.
<mean> A numeric parameter that specifies the mean throughput
class.