Motorola g20 - Table 116. +FTS Parameters; Table 117. +FRS Parameters

98-08901C68-O 231
AT Commands Reference
The following table shows the +FTS parameters.
Example
At+fclass=1
OK
Atd035658584
CONNECT 9600
OK
AT+FTS=20
OK
4.14.1.3 +FRS, Receive Silence
This command causes the g20 to wait for silence and to report back an OK result code when silence has been present on the line
for the specified amount of time. The command terminates when the required amount of silence on the line is detected or when
the terminal sends the g20 a character other than <DC1> (11h) or <DC3> (13h), which is discarded. In either event, the OK
result code is returned to the terminal.
Set Command
The Set command specifies the amount of time the line must be silent.
The following table shows the +FRS parameters.
Table 116. +FTS Parameters
<Parameter> Description
<Time> The time the terminal waits, in 10 millisecond intervals
0-255 Number of milliseconds
Command Response/Action
+FRS = <Time> OK
or:
+CME ERROR: <err>
Table 117. +FRS Parameters
<Parameter> Description
<Time> The duration of the silence, in 10 millisecond intervals.
0-255 Number of milliseconds.